Simplify3D

22 Apr 2017

Tiny Fins Triumph?

Submitted by Theverant
Print Duration: 
2 hours 37 min

Seems to be better?!?!

A lot stronger, but still fairly weak at wing inserts.  Acceptable.

 

Used 0.2 for the straight parts, 0.1 for the bottom fins and the tiny fin layers using S3D's multilayer setup.  Temp constant throughout @ 240

Some surface roughness on the 0.1 layers

22 Apr 2017

Props #3

Submitted by Theverant
Print Duration: 
2 hours 40 min

Worst one yet.  Increased heat seems to be causing more surface defects.  Will go the opposite direction.

22 Apr 2017

°Tiny Fin: The plot thickens

Submitted by Theverant
Print Duration: 
2 hours 4 min

2 x MQ9-FuseNose_RW_NLG_MS-0.4OptimisedV3 Raising the support to full touch helped the top fin.  Still messy though.  May need to be thickened.  Will use S3D to drop temps for small fin section as well.

 

Piece was also weak.  Increasing temp 5°C.  Increasing shell from 2 to 3

Pages

Subscribe to RSS - Simplify3D