12 fuselages. Straight plated in Simplify3D
The struggle continues... 2UP. Moderate succes. Prints weak due to underextrusion (?) walls did not bond horizontally. - Up extrusion and temps slightly.
cleaner print @235. All other parameters the same.
Finally improved on surface quality. Someof the props didn't print properly. Retract set to 0.6 now. Will up temp back to 235.
Worst one yet. Increased heat seems to be causing more surface defects. Will go the opposite direction.
Try#2 Good bed adhesion. Poor surface quality - will raise nozzle temp another 5°C.
100% sizing. Worked as expected. Seperated easily from raft. Some roughness. Prop pins pressure fit snugly.
Printed with HIPS.
S3D's initial temp of 245 seemed to be too high with sagging on small parts. Adjusted in print to 235 with improvements in surface quality.