cleaner print @235. All other parameters the same.
Finally improved on surface quality. Someof the props didn't print properly. Retract set to 0.6 now. Will up temp back to 235.
Worst one yet. Increased heat seems to be causing more surface defects. Will go the opposite direction.
Try#2 Good bed adhesion. Poor surface quality - will raise nozzle temp another 5°C.
Poor surface quality. 240@100 on 0.25mm nozzle? Try again +5°C
100% sizing. Worked as expected. Seperated easily from raft. Some roughness. Prop pins pressure fit snugly.