12 fuselages. Straight plated in Simplify3D
The struggle continues... 2UP. Moderate succes. Prints weak due to underextrusion (?) walls did not bond horizontally. - Up extrusion and temps slightly.
Printed @ %100.
Bad scarring on surface - Suspect because the retraction was defaulted to 1.6 which seems to be much too high for E3D + MTW Extruder + ABS
Surprised supports still broke cleanly away! Must be because gap sacled up with model - wider contact area for supports, but higher gap.
cleaner print @235. All other parameters the same.
Finally improved on surface quality. Someof the props didn't print properly. Retract set to 0.6 now. Will up temp back to 235.
Seems to be better?!?!
A lot stronger, but still fairly weak at wing inserts. Acceptable.
Used 0.2 for the straight parts, 0.1 for the bottom fins and the tiny fin layers using S3D's multilayer setup. Temp constant throughout @ 240
Some surface roughness on the 0.1 layers
Props x 20. Temps all over the map, results are the same.
Worst one yet. Increased heat seems to be causing more surface defects. Will go the opposite direction.
2 x MQ9-FuseNose_RW_NLG_MS-0.4OptimisedV3 Raising the support to full touch helped the top fin. Still messy though. May need to be thickened. Will use S3D to drop temps for small fin section as well.
Piece was also weak. Increasing temp 5°C. Increasing shell from 2 to 3
Try#2 Good bed adhesion. Poor surface quality - will raise nozzle temp another 5°C.